Tilt Level Switch

The TILT probe is to be hanged from the top in the hopper or supported on the walls of hopper at required locations. When material level rises, makes a cone in the hopper. When the material touches the probe and the probe gets tilted, the contact is actuated. Suitable for almost every material solid, powder, granule but only for dry free flowing solids. As the probe is to be hanged in the hopper user has to ensure that the falling material flow does not fall directly on the sensor.

• Supply voltage : 110/240 V AC,50 Hz.
• OFF Delay : 1 to 10 secs (Continuously Adjustable).
• ON Delay : 1 to 10 secs (Continuously Adjustable).
• Output contacts : 2 C/O relay contact.
• Contact rating : 5 Amp. resistive at 240 V AC.
• Sensor probe : 38 mm diameter x 250 mm long. Enclosure
• For Control circuit : Cast Al, IP 65 / DIN Rail / Flameproof

Q: What is the diameter of the Tilt Level Switch?

Q: What is the sensor type of the Tilt Level Switch?

Q: What is the output of the Tilt Level Switch?

Q: What is the warranty period for the Tilt Level Switch?

Q: What is the weight of the Tilt Level Switch?